Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Installation for Chesapeake Homeowners
When your garage door shudders, sags, or takes three tries to close, the whole house feels it. Your garage is likely the door you use most, and a worn-out one turns every school run, grocery trip, and late arrival into a wrestling match. That’s where we come in. Our technicians have up to 9 years of experience installing and adjusting doors from Amarr, Wayne Dalton, Craftsman, and Raynor, and we bring that hands-on knowledge to every job in Chesapeake. We start with a free measure and a written estimate, quoted and agreed before any work begins, so you know the number before we touch the door. Call (877) 419-7485 to book your measure. We answer 24/7.
What Our Garage Door Installation Service Includes
Installation isn’t a one-size job. The door you need depends on the width of your opening, whether your garage is attached or detached, how much headroom you have above the tracks, and how you want the house to look from the street. Here’s how we break it down.
New Door Installation
This is the full package: removing the old door and hardware, setting new tracks and spring systems, hanging the panels, balancing the door, and dialing in the opener so it travels smoothly from open to closed. You need it when a door has reached the end of its usable life, when the panels are dented beyond sensible repair, or when you’re changing the size or style of the opening. We measure the opening and the headroom first, because a door that’s ordered even an inch off won’t hang right.

Single Car Door
A single car door is the standard 8 to 9 foot wide door that covers one parking bay, and it’s the most common replacement we handle in Chesapeake. These come in low-headroom and standard-lift configurations, and the choice matters in tighter garages where the ceiling sits close to the opening. We check clearance before ordering so the door and opener work in your actual space, not on paper.

Double Car Door
A double car door covers 16 feet of opening and carries far more weight than a single, which means the spring system and reinforcement have to match. You’ll want one when your opening is that wide and you’re replacing an aging sectional, or when you’re reworking a garage that was previously open or fitted with two narrower doors. We size the torsion setup to the weight of the door itself so the panels lift evenly across the full span.

Custom Garage Door
Custom work covers non-standard widths, unusual heights, architectural styles that don’t come off a shelf, and openings that were framed by a previous owner to a size you can’t easily change. You need it when a stock door simply won’t fit the opening or match the house. We walk the opening with you, confirm the measurements, and specify the door around what your garage actually is.
Steel Doors
Steel is the workhorse choice: strong, low maintenance, and available in insulated and non-insulated versions. It’s the right pick when you want a durable door that holds up to daily use and doesn’t need painting every few years. We fit steel sectional doors and make sure the panel seams sit tight, since a poorly aligned steel door rattles and wears at the hinges.
Wood Doors
Wood doors bring a warmth and character that steel can’t match, and they suit Craftsman-style and traditional homes across Chesapeake. You’d choose wood when curb appeal matters and you’re willing to keep up with the finish. Wood is heavier, so the spring system and opener have to be sized for the extra weight, and we account for that before the door goes up rather than after.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Installation
We work on the brand already on your garage, and we know the differences that matter. Amarr builds a wide range of steel and insulated sectional doors, and we’re familiar with how their panel profiles and hardware line up during installation, which cuts down on adjustment time after the door is hung. Wayne Dalton doors show up on a lot of homes in this area, and we know their track and spring configurations well enough to spot the right fit before the door is ordered.
Craftsman doors and openers are common on homes that were built or updated with a matching system, and we understand how those components integrate so the door and opener work as one unit. Raynor is another brand we handle, and their commercial-grade construction means the spring sizing and balance have to be right from the start. Whether you have Amarr, Wayne Dalton, Craftsman, or any other make, we can help. If you’re still deciding between repairing what you have and starting fresh, our garage door repair team can tell you honestly which makes more sense.
Signs You Need Garage Door Installation Right Now
- The door sags or looks crooked when closed. A door that sits unevenly at the floor usually means the structure or the springs have given out. It can also let water and pests in along the gap, so it’s worth a look before the problem spreads.
- Panels are dented, cracked, or separating. Impact damage and age both take a toll. Once several panels are compromised, replacing the door is usually more sensible than chasing panel after panel.
- The door shakes, jerks, or hangs on the tracks. This points to worn rollers, bent tracks, or a door that’s no longer balanced. A door that jumps can drop suddenly, so treat it as a safety issue rather than a nuisance.
- You’re repairing the same part over and over. Repeat failures on an older door often mean the whole system is past its useful life. At that point the money goes further toward a new door than another round of repairs.
- The door no longer keeps the weather out. Gaps at the bottom and sides let in drafts, rain, and heat. A properly fitted new door with a fresh seal closes that gap and keeps the garage drier.
Our Garage Door Installation Process – Step by Step
- 1
Free measure and written estimate. We come out, measure the opening width, height, and headroom above the tracks, and look at how the door is framed. You get a written price before anything is ordered or removed, and that written estimate sets the final price.
- 2
Door selection and ordering. We help you pick the style, material, and insulation level that suits your garage and your budget, and confirm the size against our measurements. This is where a stock door and a custom fit get sorted out.
- 3
Removal and prep. On install day we take down the old door, tracks, and hardware, and check that the framing and opening are sound. If something underneath needs attention, we tell you before we go further.
- 4
Installation and balancing. We set the new tracks, hang the spring system, mount the panels, and balance the door so it lifts with steady, even pressure. Springs are tensioned with the right tools and the door is cycled to confirm it travels cleanly. This is the most mechanically dangerous part of the job, and it’s done by trained hands, never as a DIY project.
- 5
Opener setup and final test. We connect and adjust the opener, set the travel limits and safety reverse, and run the door through a full cycle with you watching. You leave with a door that opens, closes, and seals the way it should.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Installation Cost in Chesapeake?
A typical new door installation in Chesapeake runs $700 – $2,200, depending on the size of the opening, the material, and whether the door is insulated. A single car door generally lands toward the lower end, while a double car door or a custom size pushes toward the top. Wood doors usually cost more than steel because of the material and the extra weight the hardware has to handle.
What moves the number: door size, material, insulation, window inserts, the condition of the opening and framing, and whether a new opener is part of the job. Opener installation, if you need one, runs a separate $250 – $550. If you’re comparing quotes, ask what’s included: removal and haul-away of the old door, new tracks and springs, balancing, and opener adjustment should all be in the written estimate. A quote that leaves those out isn’t cheaper, it’s just incomplete. Our estimate is free, and there’s no surprise on the invoice, because the price is quoted and agreed before we start.
| Service | Typical estimated range |
|---|---|
| New door installation (single or double) | $700 – $2,200 |
| Opener installation | $250 – $550 |
| Panel replacement (if repair makes more sense) | $250 – $500 |
These are typical estimated ranges for the Chesapeake market, and the written estimate sets your final price.
Garage Door Installation Near Chesapeake – Our Service Area
We connect homeowners across Chesapeake with local pros who handle installation, and we also cover nearby Portsmouth, Norfolk, Suffolk, and Virginia Beach, along with Carrollton, Benns Church, Smithfield, Windsor, Hampton, Carrsville, and Bethel Manor. Scheduling is based on the measure and the door order, so we’ll give you a clear window when we book the job. If you’re in Portsmouth or Virginia Beach, see our garage door installation page for local details. For the full picture of what we handle, start at Chesapeake Garage Door Repair Experts.
Serving Chesapeake, VA – Our Local Coverage Area
We serve Chesapeake and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Installation in Chesapeake
Garage door installation is the full replacement of your existing door and its hardware with a new door, tracks, springs, and rollers. It includes measuring the opening, ordering the right size and style, removing the old door, hanging and balancing the new one, and adjusting the opener. It’s different from a repair, which fixes a component that’s failed. When a door has structural damage or is past its useful life, installation is the better route.
Most single car door installations take a few hours, and double car or custom doors can take longer, especially if the opening needs prep work. The measure and ordering happen first, so the install day itself is scheduled around the door arriving. We’ll give you a clear time estimate when we book the job, so you can plan your day.
A typical new door installation in Chesapeake runs $700 – $2,200, depending on size, material, and insulation, with opener installation at $250 – $550 if you need one. Custom sizes and wood doors sit toward the top of those ranges. These are typical estimated ranges; the written estimate sets your final price after we measure. Call (877) 419-7485 for an exact quote. Estimates are free.
Yes. We service Amarr and Wayne Dalton doors, along with Craftsman and Raynor, and we know how each brand’s panels, tracks, and spring setups differ. That familiarity means we’re not guessing at the fit when the door arrives. Tell us the brand and model when you call and we’ll confirm what’s needed.
Installation is measured, ordered, and scheduled, so it isn’t a same-day job the way a repair can be. We do offer same-day service on repairs, and fast dispatch from 7am to 7pm, Sunday through Friday. We answer 24/7, so call whenever it’s convenient and we’ll get your measure on the books.
Warranty coverage depends on the door and opener manufacturer, and we walk you through what’s covered before you commit. We also stand behind our installation work, so if something isn’t right after the job, you call one number and we make it right. Ask about the specifics for the door you’re considering during your free estimate.
Clear the garage floor around the door and move anything parked directly under the opener so the crew has room to work. If the garage is attached, expect a few hours of noise and some dust from removing the old door. Take down anything fragile hanging on the walls near the tracks. That’s usually all it takes to get ready.
Schedule Your Garage Door Installation Service in Chesapeake Today
If your door is sagging, dented, or just past its prime, a free measure is the quickest way to know what a new door will cost. We’ll measure the opening, walk you through the options, and give you a written price before any work starts. At garage door installation in Chesapeake, our practice is simple: measured right, installed right, adjusted right. Call (877) 419-7485. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. There’s no obligation, and the estimate is free.
Written by the team at Chesapeake Garage Door Repair Experts.